测试方法(完全干燥后): 1.3M胶纸粘在画有百格的油墨表面45度角迅速拉起不脱油。 2.纯度99%的酒精500G力在油墨表面来回擦拭500次无脱色。 使用方法: 1.使用前应充分搅拌,用后随时密封。 2.搅拌时先加固化剂静置10分钟后,再加稀释剂10-15%,稀释到印刷粘度。 3.网版塞网时可用洗网水清洗。 4.不得与其它类型油墨混合使用。 注意事项: 1.各种物料的外观相似,但可能会是不同的材料,客户需先试印,确其符合要求后,再批量生产。 2.在移印过程中,如出现拉丝或散开现象,可适当加入一些慢干膏即可。 3.环境温度过高,将会影响油墨原有质量。 4.请远离火源,避光保存。Details: product name: the rice details: Chris strengthen ink overview: this product is mainly used for PC and YingPian materials, PMMA dumb g strength add YingPian material (1 H-4 H), and other products, has the high color, high covering power, high stability and resistance to alcohol, especially, the characteristics of friction resistance. Purposes: 1. To add 10 � 5 � and � � JS-9 curing agent, need not roasted, can adhere to the PC and YingPian materials, PMMA dumb g strength add YingPian material (1 H-4 H), and spray PU paint surface spray paint surface, UV and special material, good adhesion, alcohol resistance, resistance to friction. Increase the proportion of added curing agent, can strengthen adhesion, but will slow down the ink drying speed, when the curing agent proportion than add 20 � and � �, it is necessary to roast dry. (note: add hardener used for the printing ink of time after 4 ~ 6 hours, the higher the environment temperature using time is shorter, the remaining printing ink, add after curing agent shall not recycling of printing ink test time for 24 hours later). Printing: choose the mesh is 250-400 mesh, silk screen moving printing all can. Dry time table natural volatilize 5-10 minutes, action in 24 time time, within 48 hours after the best performance. 1. To use B-03 special thinner, open oil. 2. Use 718 wash nets washing nets.